Finite element analysis of an excavator bucket with embedding ripper teeth

  • Aurora Potîrniche “Dunărea de Jos” University of Galați, Engineering Faculty of Brăila
  • Gigel Căpățână “Dunărea de Jos” University of Galați, Engineering Faculty of Brăila
DOI: https://doi.org/10.35219/im.2017.1.01
Keywords: Leading Edge bucket, bucket with ripper teeth, 3D model, specialized software of finite element analysis, state of stresses and deformations

Abstract

This paper deals with the study of a special excavator bucket, namely the Leading Edge bucket, which is a bucket with embedding ripper teeth. This type of equipment has been taken over from the literature, the 3D model has been generated in the Solid Edge assisted design software, then a detail has been chosen from the bucket assembly, namely a tooth, and it has been introduced in a specialized software of finite element analysis, namely Algor, and subjected to an analysis. The goal of the finite element analysis was to observe the state of stresses and deformations that occur in the structure during the digging process, when multidirectional
stresses act on the bucket. The results obtained may be used by those skilled in the domain to improve the work performances of such equipment.

Published
2017-07-20
How to Cite
1.
Potîrniche A, Căpățână G. Finite element analysis of an excavator bucket with embedding ripper teeth. Analele Universităţii "Dunărea de Jos" din Galaţi. Fascicula XIV, Inginerie mecanică = Annals of “Dunarea de Jos“ University of Galati. Fascicle XIV, Mechanical Engineering [Internet]. 20Jul.2017 [cited 15Jan.2025];24(1):5-0. Available from: https://gup.ugal.ro/ugaljournals/index.php/im/article/view/1662
Issue
Vol 24 No 1 (2017)
Section
Articles