Some Researches on the Cutting Process Using a Stamping Device
Keywords:
cutting process, stamping force
Abstract
The cutting process of the parts from the plates and strips consists in the action of two active elements of the stamping machine: device punch and active plate. The main actors on which the cutting process depends are the thickness and the mechanical characteristics of the material to be cut, the state of the edges of the active elements and the clearance between the active elements. This paper presents the results of the research on the variation of the stamping force depending on the thickness and the stamp clearance for the maximum cutting force.
Downloads
Download data is not yet available.
References
[1]. Teodorescu, M. – Elemente de proiectare a stantelor si matritelor, EDP, Bucuresti, 1977.
[2]. Roamnovski, V.P. – Stantarea si matritarea la rece, Ed. Tehnica, bucuresti, 1970.
[3]. Lazarescu, I., Stetiu G. – Proiectarea stantelor si matritelor, EDP, Bucuresti, 1973.
[4]. Merchant, E.M. – Mechanics of the metal cutting proces, Journal of applied physics, M.C. Shaw, 2004.
[5]. Jaspers, S. – Material behaviour in conditions similar to metal cutting flow stress in the primary zone, Journal of Material Processing Technology, vol. 122, issues 2-3, march 2002, p. 322-330.
[6]. Nagîţ, Gh., Braha, V. – Bazele prelucrarii prin deformare plastica, Ed. Tehnica, Chisinau, 2002.
[7]. ***, ASM, Metal Handbook, vol. 4, Ohio, 1969.
[2]. Roamnovski, V.P. – Stantarea si matritarea la rece, Ed. Tehnica, bucuresti, 1970.
[3]. Lazarescu, I., Stetiu G. – Proiectarea stantelor si matritelor, EDP, Bucuresti, 1973.
[4]. Merchant, E.M. – Mechanics of the metal cutting proces, Journal of applied physics, M.C. Shaw, 2004.
[5]. Jaspers, S. – Material behaviour in conditions similar to metal cutting flow stress in the primary zone, Journal of Material Processing Technology, vol. 122, issues 2-3, march 2002, p. 322-330.
[6]. Nagîţ, Gh., Braha, V. – Bazele prelucrarii prin deformare plastica, Ed. Tehnica, Chisinau, 2002.
[7]. ***, ASM, Metal Handbook, vol. 4, Ohio, 1969.
Published
2011-03-15
How to Cite
1.
CANANAU N, DIMA O, TANASE D. Some Researches on the Cutting Process Using a Stamping Device. The Annals of “Dunarea de Jos” University of Galati. Fascicle IX, Metallurgy and Materials Science [Internet]. 15Mar.2011 [cited 26Dec.2024];34(1):43-6. Available from: https://gup.ugal.ro/ugaljournals/index.php/mms/article/view/2965
Issue
Section
Articles
