Method to Calculate Oscillatory Die Volumetric Deformation Process Specific Parameters

  • Constantin Stoian “Dunarea de Jos“ University of Galati

Résumé

Deformation process by using an oscillatory die is more convenient than conventional volumetric forming, because it requires, to obtain the same piece, a smaller manufacturing force (in the conditions of a floating contact surface) and allows higher deformation degrees, due to a slower cold hardening process. The paper suggests a calculus method to evaluate the forming force and the torque applied to oscillatory shaft. 

##plugins.generic.usageStats.downloads##

##plugins.generic.usageStats.noStats##
Publiée
2006-09-15
Comment citer
1.
Stoian C. Method to Calculate Oscillatory Die Volumetric Deformation Process Specific Parameters. Annals of ”Dunarea de Jos” University of Galati, Fascicle V, Technologies in machine building [Internet]. 15sept.2006 [cité 26avr.2025];24:11-4. Available from: https://gup.ugal.ro/ugaljournals/index.php/tmb/article/view/2059
Rubrique
Articles