Design an experimental reconfigurable die for sheet metal forming

  • Viorel Păunoiu “Dunarea de Jos“ University of Galati
  • Dumitru Nicoară “Dunarea de Jos“ University of Galati
  • Mihaela Banu “Dunarea de Jos“ University of Galati
  • Cătălina Maier “Dunarea de Jos“ University of Galati
  • Ovidiu Ciocan
  • Alexandru Epureanu “Dunarea de Jos“ University of Galati

Résumé

The reconfigurable surface tooling is based on the concept of discrete approximation of a die continuous surface with a number of closely spaced rigid pins. The heights of the pins can be adjusted to approximate the desired surface shapes either manually or using a computer control. In the paper are analyzed some of main parameters of the deep drawing with reconfigurable die and based on this are presented the results of the development of a reconfigurable die in the present research activity.

##plugins.generic.usageStats.downloads##

##plugins.generic.usageStats.noStats##
Publiée
2006-09-15
Comment citer
1.
Păunoiu V, Nicoară D, Banu M, Maier C, Ciocan O, Epureanu A. Design an experimental reconfigurable die for sheet metal forming. Annals of ”Dunarea de Jos” University of Galati, Fascicle V, Technologies in machine building [Internet]. 15sept.2006 [cité 20avr.2025];24:60-5. Available from: https://gup.ugal.ro/ugaljournals/index.php/tmb/article/view/2072
Numéro
Vol. 24 (2006)
Rubrique
Articles

##plugins.generic.recommendByAuthor.heading##

1 2 3 > >>