The influence of the geometry of the lathe tool on the surface condition at the processing of the polyamide PA 66 – GF 30

  • Marin Moțoi-Cristescu University of Piteşti

Résumé

As it is known, the surface condition has two constituents: dimensional accuracy and roughness of the machined surface. In this study it is presented only the condition of the machined surface from the roughness point of view. As regards the geometry of the lathe tool, this study presents only the influence of two tool parameters: radius of the tool point and the end cutting edge angle.

##plugins.generic.usageStats.downloads##

##plugins.generic.usageStats.noStats##
Publiée
2005-06-10
Comment citer
1.
Moțoi-Cristescu M. The influence of the geometry of the lathe tool on the surface condition at the processing of the polyamide PA 66 – GF 30. Annals of ”Dunarea de Jos” University of Galati, Fascicle V, Technologies in machine building [Internet]. 10juin2005 [cité 7juin2025];23:74-9. Available from: https://gup.ugal.ro/ugaljournals/index.php/tmb/article/view/2148
Rubrique
Articles