Dust Emissions from an Integrated Steel Mill in Correlation with Human Exposure and their Adverse Health Effects

  • Anișoara CIOCA "Dunarea de Jos" University of Galati, Romania
  • Tamara RADU "Dunarea de Jos" University of Galati, Romania
Keywords: dust emissions, particulate matter, integrated steel mill, health status

Abstract

Many of the metallurgical operations contribute to generation of the dust emissions if these are not properly controlled and managed. The relevant sectors as important sources for airborne dust are: coke oven plant, sintering equipments, blast furnaces, basic oxygen steelmaking, steel mills and also handling, preparation and transport of raw materials, products, by-products and residues. The annual average values of dust for metallurgical plant and period analysed not exceeds allowable level. The measurements showed that the daily average determined for settled dust varies very high. Sometimes, certain of these exceed the limits of the rules in force for air quality indicators. As result at exposure to generated dust (especially to particulate matter) appear adverse health problems at workers and population that lives in the neighbourhood of steelwork plant. Impact of dust emissions as air pollutant on the population of the vicinity areas is correlated with levels of incidence and prevalence of some specifically diseases. The indicators calculated for evaluation the health status (severity index, relative risk, professional etiological fraction) did not demonstrate the adverse health effects determined by exposure to dust particles in suspension on population that lives in vicinity of the plant. This influence is more likely to workers directly involved in metallurgical activity.

Creative Commons License

Downloads

Download data is not yet available.

References

[1]. *** - Best Available Techniques Reference Document on the Production of Iron and Steel, December 2001, available on www.epa.ie/downloads/advice/brefs/Iron%20&%20Steel.pdf.
[2]. H. Schoenberger - Final draft: best available techniques reference document on the production of iron and steel, Publications of EC: European Commission, Joint Research Centre, IPTS, European IPPC Bureau, 2001.
[3]. R. Remus, M.A. Aguado-Monsonet, S. Roudier, L. Delgado Sanch - Best Available Techniques (BAT) Reference Document for Iron and Steel Production, European Commission Joint Research Centre Institute for prospective technological studies, 2013, available on http://eippcb.jrc.es/reference/BREF/IS_Adopted_03_2012.pdf.
[4]. *** - Environmental, Health, and Safety Guidelines for Integrated Steel Mills, WORLD BANK GROUP, apr. 2007, www.ifc.org/ifcext/enviro.nsf/Content/EnvironmentalGuidelines.
[5]. *** - Directive 2008/50/EC on ambient air quality and cleaner air for Europe, available on http://ec.europa.eu/environment/air/legis.htm.
[6]. H.U. Wanner - Effects of atmospheric pollution on human health, Journal of Aerosol Science, Volume 21, Supplement 1, 1990, pp. S389–S396, Proceedings of the 1990 European Aerosol Conference.
[7]. *** - U.S. Environmental Protection Agency, National Emission Standards for Hazardous Air Pollutants: Integrated Iron and Steel Manufacturing; Final Rule, (United-States: 40 CFR Part 63, Federal Register/ Vol. 68, No. 97, May 20, 2003), www.epa.gov.
[8]. R. Heather - Particulate emissions from a steel works: A quantitative ecological assessment, thesis for the degree of Master of Philosophy, 2008, http://etheses.dur.ac.uk/2063/.
[9]. *** - Monitoring of particulate matter in ambient air around waste facilities. Rep. No. 1 844 322610. 2004, Environment Agency, Bristol.
[10]. D.A. Grantz, J.H.B. Gamer, D.W. Johnson - Ecological effects of particulate matter. Environment International, 29 (2-3), 2003, pp.213-239.
[11]. *** - Hazard Prevention and Control in the Work Environment: Airborne Dust WHO/SDE/OEH/99.14, Chapter 1 - Dust: Definitions and Concepts, http://www.who.int/occupational_health/publications/en/oehairbornedust3.pdf.
[12]. *** - Pollution Prevention and Abatement Handbook, WORLD BANK GROUP, Airborne Particulate Matter, July 1998, www-wds.worldbank.org.
[13]. *** - Integrated pollution prevention and control, Production of Iron and Steel, draft February 2008, http://eippcb.jrc.es.
[14]. *** - Best Available Techniques (BAT) Reference Document for Iron and Steel Production, Industrial Emissions Directive 2010/75/EU (Integrated Pollution Prevention and Control), JOINT RESEARCH CENTRE, Institute for Prospective Technological Studies Sustainable Production and Consumption Unit, European IPPC Bureau, http://eippcb.jrc.ec.europa.eu/.
[15]. Nalini Bhat et.al. - Technical EIA guidance manual for metallurgical industry, Prepared for Ministry of environment and forests, Government of India, august 2010.
[16]. *** - Iron And Steel Production, Metallurgical Industry, 10/86 (Reformatted 1/95), http://www.epa.gov.
[17]. *** - General review of Sintering section of BREF, Eurofer 2007.
[18]. *** - 02 First draft of the revision of the BREF on Production of Iron and Steel (Feb 2008), http://eippcb.jrc.es/.
[19]. W. Lemmon & Associates Ltd. - Research on Technical Pollution Prevention Options for Iron Sintering, Draft of 2003/05/17 (Canada: prepared for the Canadian Council of Ministers of the Environment, 2003.
[20]. P. Finlay et.al. - Section V.D.2., Guidance by source category: Annex C, Part II Source Categories, Sinter plants in the iron industry, DRAFT 22/04/04.
[21]. *** - Studiu de evaluare a riscului la ISPAT-SIDEX Galaţi, ICEM S.A. Bucureşti.
[22]. *** - Raport la Bilanţ de mediu nivel II pentru ISPAT-SIDEX Galaţi. ICEM S.A. Bucureşti.
[23]. M. Koponen, T. Gustafsson, K. Kalliomäki, P.L. Kalliomäki, M. Moilanen, L. Pyy - Dusts in a steel-making plant, International Archives of Occupational and Environmental Health, October 1980, Volume 47, Issue 1, p. 35-45.
Published
2013-12-15
How to Cite
1.
CIOCA A, RADU T. Dust Emissions from an Integrated Steel Mill in Correlation with Human Exposure and their Adverse Health Effects. The Annals of “Dunarea de Jos” University of Galati. Fascicle IX, Metallurgy and Materials Science [Internet]. 15Dec.2013 [cited 25Dec.2024];36(4):27-6. Available from: https://gup.ugal.ro/ugaljournals/index.php/mms/article/view/2656
Section
Articles

Most read articles by the same author(s)

1 2 3 > >>